8 Port Fast Ethernet Smart POE Switch

8 × 10/100 Mbps PoE ports, 1 × Gigabit RJ45 port
Total PoE Power Budget 60 W
Support 802.1Q VLAN
Support PoE watchdog to detect and restart the cameras that do not respond
Support STP/RSTP Loop prevention
Support cable detection to locate failure
Up to 300 m Long Range PoE Transmission
6 kV Surge Protection

View Less

Data Sheet

Sales Inquiry

Available models:

DS-3E1309P-EI/M

Data Sheet

General
CarcasaMetal material, fan-free design
Peso neto0.4 kg (0.9 lb)
Peso bruto0.9 kg (2.0 lb)
Dimensiones (W x H x D)170.00 mm × 27.60 mm × 93.10 mm (6.69'' × 1.09'' × 3.67'')
Temperatura de funcionamiento0 °C to 40 °C (32 °F to 104 °F)
Temperatura de almacenamiento-40 °C to 85 °C (-40 °F to 185 °F)
Condiciones de humedad5% to 95% (no condensation)
Humedad relativa5% to 95% (no condensation)
Fuente de alimentación54VDC, 1.2A
Modo de instalaciónDesk-Mounted,Wall-Mounted
Max. El consumo de energía65 W
Consumo de energía en inactivo5 W
Surge Protection6 kV

Parámetros de red
Puertos8 × 10/100 Mbps PoE port,1 × Gigabit RJ45 port
Tabla de direcciones MAC8 K
Capacidad de conmutaciónWhole-Device Performance: 5.6 Gbps Port Performance: 3.6 Gbps
Tasa de reenvío de paquetesWhole-Device Performance: 4.17 Mpps Port Performance: 2.68 Mpps
Caché interna4 Mbits

Fuente de alimentación PoE
PoE StandardIEEE 802.3af,IEEE 802.3at
Pin de alimentación PoEEnd-span: 1/2(-), 3/6(+)
Puerto PoEPoE: Ports 1 to 8
Max. Puerto de alimentación30 W
PoE Power Budget60 W

Función de software
Largo alcancePorts 1 to 8: up to 300 m. Long range performance may vary depend on camera model or cable condition.
HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
Port IsolationPorts 1 to 8: port isolation mode to improve network security Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
System MaintenanceSupport device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Supports 802.1ab LLDP for peer device discovery. Support port mirroring for fault locating.
PoE WatchdogPorts 1 to 8: auto detect and restart the cameras that do not respond.
Loop PreventionLoop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default. Support 802.1D STP. Suppport 802.1w RSTP.
VLANVLAN is used for network scale planning and network health improvement. Support 802.1Q. Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 4094 VLAN.

Certificaciones
EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
SeguridadCB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition)), CE-LVD (EN 62368-1: 2014+A11: 2017)
QuímicaCE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)

General

Carcasa

Metal material, fan-free design

Peso neto

0.4 kg (0.9 lb)

Peso bruto

0.9 kg (2.0 lb)

Dimensiones (W x H x D)

170.00 mm × 27.60 mm × 93.10 mm (6.69'' × 1.09'' × 3.67'')

Temperatura de funcionamiento

0 °C to 40 °C (32 °F to 104 °F)

Temperatura de almacenamiento

-40 °C to 85 °C (-40 °F to 185 °F)

Condiciones de humedad

5% to 95% (no condensation)

Humedad relativa

5% to 95% (no condensation)

Fuente de alimentación

54VDC, 1.2A

Modo de instalación

Desk-Mounted,Wall-Mounted

Max. El consumo de energía

65 W

Consumo de energía en inactivo

5 W

Surge Protection

6 kV

Parámetros de red

Puertos

8 × 10/100 Mbps PoE port,1 × Gigabit RJ45 port

Tabla de direcciones MAC

8 K

Capacidad de conmutación

Whole-Device Performance: 5.6 Gbps Port Performance: 3.6 Gbps

Tasa de reenvío de paquetes

Whole-Device Performance: 4.17 Mpps Port Performance: 2.68 Mpps

Caché interna

4 Mbits

Fuente de alimentación PoE

PoE Standard

IEEE 802.3af,IEEE 802.3at

Pin de alimentación PoE

End-span: 1/2(-), 3/6(+)

Puerto PoE

PoE: Ports 1 to 8

Max. Puerto de alimentación

30 W

PoE Power Budget

60 W

Función de software

Largo alcance

Ports 1 to 8: up to 300 m. Long range performance may vary depend on camera model or cable condition.

HPP

Support one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.

Port Isolation

Ports 1 to 8: port isolation mode to improve network security Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.

System Maintenance

Support device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Supports 802.1ab LLDP for peer device discovery. Support port mirroring for fault locating.

PoE Watchdog

Ports 1 to 8: auto detect and restart the cameras that do not respond.

Loop Prevention

Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default. Support 802.1D STP. Suppport 802.1w RSTP.

VLAN

VLAN is used for network scale planning and network health improvement. Support 802.1Q. Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 4094 VLAN.

Certificaciones

EMC

CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)

Seguridad

CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition)), CE-LVD (EN 62368-1: 2014+A11: 2017)

Química

CE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)

General

CarcasaMetal material, fan-free design
Peso neto0.4 kg (0.9 lb)
Peso bruto0.9 kg (2.0 lb)
Dimensiones (W x H x D)170.00 mm × 27.60 mm × 93.10 mm (6.69'' × 1.09'' × 3.67'')
Temperatura de funcionamiento0 °C to 40 °C (32 °F to 104 °F)
Temperatura de almacenamiento-40 °C to 85 °C (-40 °F to 185 °F)
Condiciones de humedad5% to 95% (no condensation)
Humedad relativa5% to 95% (no condensation)
Fuente de alimentación54VDC, 1.2A
Modo de instalaciónDesk-Mounted,Wall-Mounted
Max. El consumo de energía65 W
Consumo de energía en inactivo5 W
Surge Protection6 kV

Parámetros de red

Puertos8 × 10/100 Mbps PoE port,1 × Gigabit RJ45 port
Tabla de direcciones MAC8 K
Capacidad de conmutaciónWhole-Device Performance: 5.6 Gbps Port Performance: 3.6 Gbps
Tasa de reenvío de paquetesWhole-Device Performance: 4.17 Mpps Port Performance: 2.68 Mpps
Caché interna4 Mbits

Fuente de alimentación PoE

PoE StandardIEEE 802.3af,IEEE 802.3at
Pin de alimentación PoEEnd-span: 1/2(-), 3/6(+)
Puerto PoEPoE: Ports 1 to 8
Max. Puerto de alimentación30 W
PoE Power Budget60 W

Función de software

Largo alcancePorts 1 to 8: up to 300 m. Long range performance may vary depend on camera model or cable condition.
HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
Port IsolationPorts 1 to 8: port isolation mode to improve network security Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
System MaintenanceSupport device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Supports 802.1ab LLDP for peer device discovery. Support port mirroring for fault locating.
PoE WatchdogPorts 1 to 8: auto detect and restart the cameras that do not respond.
Loop PreventionLoop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default. Support 802.1D STP. Suppport 802.1w RSTP.
VLANVLAN is used for network scale planning and network health improvement. Support 802.1Q. Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 4094 VLAN.

Certificaciones

EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
SeguridadCB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition)), CE-LVD (EN 62368-1: 2014+A11: 2017)
QuímicaCE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)